Avery Weigh-Tronix WI-150, Руководство по обслуживанию

Страница: 24 / 46

21
Reset Menu
The only items active for a
reset or master clear are those
items that are not set to the
factory defaults.
If
SETUP, ADJUST, or DATA appears and it is flashing, the indicator is
telling you that it is corrupted and must be reset to default values.
If ALL appears, you have the option to reset all values to their default
settings simultaneously.
If ALL is flashing, the indicator is telling you that SETUP, ADJUST, and
DATA are all corrupted and you must reset them all to default values. If you
choose
ALL, the unit returns automatically to weighing mode. All factory
defaults are now in place, including calibration values.
To reset any of the choices, use the MENU key to toggle between the
choices. When the correct choice is displayed, press SELECT, then press
GROSS/NET to save.
If you choose to reset some choices, but not all, the unit will return to
weighing mode when you press GROSS/NET. If nothing is corrupted (no
choices are flashing) you can return to weighing mode by pressing SELECT
while
END (after RESET) is displayed.
The following are instructions for moving around within the Configuration
Menu:
If a new microprocessor is installed in the WI-150, the COP (Com-
puter Operating Properly) watchdog system will need to be reset. Do
this by turning off the unit, placing a jumper between pin 1 and pin 2
of P7 and a jumper between pin 1 and pin 2 of P8. Turn on the unit
for a few seconds then turn off and remove the jumpers. The COP is
now reset and you are ready for normal operation.