User guide GENIO 10
Page 12
4.2.3 Config
With Config you have the possibility to decide with which preset and parameterset the program will start when
turned on. F
urther adjustments will be described below. By pressing the “preset” dial you will enter to the
Config-
menu, when the little triangle is next to “Config”. (See below)
Now you can see the startup-preset starting the program on the display. By turning the
“volume” dial you can
change with which preset the program should start with (1-
20). By turning the “preset” dial you will enter to the
startup parameter menu. Here you can select with which parameters the program should start (1-4).
VU Out
: By turning the volume dial, you can choose which of the two outputs shall be shown as VU-meters on
the display.
LCD contrast
: Set the contrast oft he LCD display from 0 to 50 for optimal readability.
Vol/Preset Protect
: The protection of the settings is such that changes (e.g. changing between presets or
temporary volume changes) can only be performed while pushing und turning the dials at the same changes
can be made by simply turning the dials without pushing them. Turning the volume dial by one click either
enable or disables the protection.
Welcomescreen Line 1
: Set the first line (16 characters) oft he welcome text that shows up when powering
up the unit. The cursor will blink under the first character. By turning the volume dial, the following letters ,
numbers and special characters will appear in this order: A-Z, Ä, Ö, Ü, a-z, ä, ö, ü, 0-9, space,
! „ # $ % & ’ ( )
* + , - . / Pushing the preset dial will confirm the current character and move the cursor one position to the
right. Now you can see the next character.
Welcomescreen Line 2
: Set the second line (16 characters) of the welcome text that shows up when
powering up the unit.
Output 1 Name
: Determine the name of the first output. 8 characters are available for this name (e.g. nave,
gallery etc.)
Output 2 Name
: Same procedure as in Output Name 1.
4.2.4 Utility
Inside this menu you have the possibility to copy a parameterset into another parameterset.
Turn the “volume” dial until the small triangle in next to “Utility” and press the “preset” dial.
Now you can see
“Copy/Firmware” on the display. By pressing the dial again the following menu
will
appear (see below)
By turning the „volume“ dial the source and target parameter set for the copy process can be determined.
When th
e triangle is on “Copy”, press the “preset” dial. Now the designed parameter set is copied.
Firmware
: Displays the current firmware version of the unit.
