Checking triggered updates for RIP interfaces
Check whether automatic triggered updates for RIP–enabled interfaces is enabled or disabled.
Procedure
1. Log on to ACLI to enter User EXEC mode.
2. Enter the
show ip rip
command.
3. Observe and note the
Triggered Update
status for RIP interfaces.
Enabling triggered updates for RIP interfaces
Ensure that the automatic triggering of updates is enabled for RIP-enabled interfaces.
Procedure
1. Enter Interface Configuration mode:
enable
configure terminal
interface Ethernet
<port>
or
interface vlan
<1–4094>
2. Enter the
ip rip triggered enable
command.
A virtual router remains in the initialize state
This section describes the troubleshooting process you can use to diagnose and resolve a situation
where a virtual router that should be in either the
Backup
or
Master
operational state, remains in the
Initialize
state.
Global IP routing status
Ensure IP routing is enabled globally for a switch or stack.
Checking the global IP routing status
Determine if IP routing is globally enabled or disabled.
Procedure
1. Log on to ACLI to enter User EXEC mode.
2. Enter the
show ip routing
command.
A virtual router remains in the initialize state
July 2015
Troubleshooting Avaya VSP 7000 Series
91
