enable
configure terminal
2. Enter the
rip maximum-path <2–4>
command.
Learned RIP routes are deleted and learned again
This section describes the troubleshooting process you can use to diagnose and resolve a situation
where routes learned on a RIP-enabled interface are continually deleted from the RIP routing table,
and then learned again.
Checking the global RIP timeout and update intervals
Display and observe the RIP timeout and update intervals configured for a standalone switch or
stack.
Procedure
1. Log on to ACLI to enter User EXEC mode.
2. Enter the
show ip rip
command.
3. Observe and note the global RIP timeout and update interval settings.
Configuring the global RIP timeout and update intervals
Ensure that the configured global update interval value is less than the configured global timeout
value for RIP peers.
Procedure
1. Enter RIP Router Configuration mode:
enable
configure terminal
router rip
2. To set the global RIP timeout interval, enter the
timers basic timeout <15–259200>
command.
3. To set the global RIP timeout interval, enter the
timers basic update <1–360>
command.
Learned RIP routes are deleted and learned again
July 2015
Troubleshooting Avaya VSP 7000 Series
89
