Avaya Media Gateway G250, Руководство администратора

Страница: 96 / 840

Basic device configuration
96 Administration for the Avaya G250 and Avaya G350 Media Gateways
Showing the current MGC list
To show the current MGC list, use the
show mgc list
command. This command shows the
IP addresses of the MGCs on the MGC list. It also shows whether or not SLS is enabled.
Removing one or more MGCs
To remove one or more MGCs from the MGC list, use the
clear mgc list
command. Type
the IP address of the MGC you want to remove as an argument to remove that MGC. You can
remove more than one MGC with one command by typing the IP addresses of all the MGCs you
want to remove, separated by commas. To remove all the MGCs on the list, enter
clear mgc
list
with no arguments.
Changing the MGC list
1. Enter
clear mgc list
with no arguments to clear the MGC list.
2. Enter
set mgc list
with a different set of IP addresses.
Note:
Note:
If you use the
set mgc list
command without first clearing the MGC list, the
G250/G350 simply adds the new MGCs to the end of the MGC list.
Setting reset times
If the connection between the G250/G350 and its registered MGC is lost, the G250/G350
attempts to recover the connection. Use the
set reset-times primary-search
command and the
set reset-times total-search
command to set the timeout for the
G250/G350’s search for the primary MGC and the other MGCs on its MGC list, respectively.
Use the
set reset-times transition-point
command to configure the point at which
the primary MGCs in the list end and the LSPs begin. For example, if there are three IP
addresses in the MGC list and the third address is the LSP, the transition point should be 2.
The default time for the primary search is one minute. The default time for the total search is 30
minutes. The default transition point is 1.
For example:
G350-001(super)# set reset-times primary-search 20
Done!
G350-001(super)# set reset-times total-search 40
Done!
G350-001(super)# set reset-times transition-point 1
Done!