Avaya Media Gateway G250, Руководство администратора

Страница: 471 / 840

Configuring and monitoring CNA test plugs
Issue 5 June 2008 471
Configuring the G250/G350 test plug for registration
From the G250/G350 CLI, you can configure the G250/G350 test plug to register with a CNA
scheduler.
1. Use the
cna-testplug
command to enter the
testplug
context. For example:
2. Use the
scheduler
command to configure one or more CNA scheduler IP addresses.
You can configure up to five scheduler addresses. The test plug attempts to register with a
scheduler according to its place on the list. By default, no schedulers are configured. At
least one scheduler must be configured for registration to be possible.
3. Use the
fingerprint
command to enter the certificate fingerprint, provided by your
administrator. The fingerprint is used by the CNA test plug to authenticate the CNA
scheduler.
4. Perform the following configurations as necessary:
●
Use the
control-port
command to configure the control port. The default control
port number is
8889
.
●
Use the
rtp-echo-port
command to configure the RTP echo port. The default RTP
echo port number is
8888
.
●
Use the
rtp-test-port
command to configure the RTP test port. The default RTP
test port number is
8887
.
●
Use the
test-rate-limit
command to configure the CNA test rate limiter. The
default test rate is 60 tests every 10 seconds.
5. If necessary, use the
no shutdown
command to enable the test plug. By default, the test
plug is enabled.
6. When the test plug configurations are complete, use the
exit
command to exit the
testplug
context. From the general context, you can enter
show cna testplug
to
display the test plug configuration.
7. From the general context, enter
cna-testplug-service
to enable the test plug
service. For example:
G350-001# cna-testplug 1
G350-001(cna-testplug 1)#
G350-001# cna-testplug-service
The Converged Network Analyzer test plug is enabled.