Avaya G600, Инструкция по установке

Страница: 69 / 274

69 Installing the Avaya™ S8700 Media Server with Avaya™ G600 Media Gateway
May 2003
Perform these tasks to install the Avaya G600 port network:
•
‘‘Set the Carrier Address ID’’ on page 69
• ‘‘Mount the Avaya G600 Media Gateway in the Rack’’ on page 70
•
‘‘Cabling the G600 Media Gateways’’ on page 82
Front view of Avaya G600 Media Gateway
Set the Carrier Address ID
Set the Carrier Address ID either before or after installing each media gateway.
1 Loosen the thumb screws on the fan assembly and pull it straight out as shown in ‘‘Fan
assembly removal’’ on page 70 . Leave the fan assembly off until the unit is completely
installed in the rack.
2
Verify and, if necessary, set the carrier address ID for each media gateway as shown in
‘‘Setting media gateway carrier address ID’’ on page 70 . "A" settings are for the media
gateway in the A location, "B" settings are for the media gateway in the B location, "C"
settings are for the media gateway in the C location, and "D" settings are for the media
gateway in the D location. "E" settings are not used in this configuration.
Figure notes
1
ESD Ground Jack
2 650A Power Supply
3
TN2312AP IP Server Interface
Circuit Pack
4
TN799DP C-LAN (optional)
5 TN2302 IP Media Processor
6
Accessory compartment
7 Cable pass-through (if needed)
2
1
scdlff01 LJK 031102
5
6
7
3 4
10 2 3 4 5 6 7 8 9 Power 1