Avaya G600, Инструкция по установке

Страница: 66 / 274

66 Installing the Avaya™ S8700 Media Server with Avaya™ MCC1 or SCC1 Media Gateway
May 2003
Connect AC Power and Ground
When installing media gateways, be aware of the following warnings and cautions.
!
WARNING:
The equipment room AC power and ground wiring must be performed by a qualified
electrician. The alternating current (AC) power circuit must be dedicated to the system.
The circuit must not be shared with other equipment and must not be controlled by a wall
switch. The AC receptacle must not be located under the Main Distribution Frame and
must be easily accessible.
!
CAUTION:
Media gateway grounding must comply with the general rules for grounding contained in
Article 250 of the National Electrical Code (NEC), National Fire Protection Agency
(NFPA) 70, or the applicable electric code in the country of installation. For more
information, refer to the job aid titled
Approved Grounds .
!
DANGER:
With a G600 Media Gateway unseating the power supply removes AC power only
from the power supply but not from the media gateway. To remove AC power from
the media gateway, pull the AC power cord from the AC appliance connector on the
rear of the media gateway.
!
WARNING:
With a G600 Media Gateway if other equipment is installed in the same rack, make sure
that the media gateway does not generate an overcurrent or overload condition. Verify that
the customer’s branch circuit and/or power distribution strip are adequate with respect to
overload and overcurrent protection.
Approved grounds
Refer to the job aid entitled Approved Grounds .