Avaya CallPilot 202i, Руководство пользователя, Страница: 81 / 92

What is next?
Replace and upgrade components, as required.
Replacing the server
Replace the server only if you are instructed to do so. For activities that are not supported as
field procedures, you must return the server to Avaya for service.
This section summarizes the procedure to replace the server. References are made to specific
component replacement procedures where applicable.
To replace the server
1. If the installed server is functional, perform a full backup of the hard disk as a
precautionary measure.
2. Shut down the installed server (see "Starting up and shutting down the Avaya
CallPilot
®
server" in the Avaya CallPilot Installation and Configuration Task List).
3. Power down the server by unseating it from the back plane. Wait 15 seconds to
complete powering down, and then remove the server.
4. Disconnect all peripherals from the server.
5. Remove the server from the switch (see
Removing the server from the switch on
page 80).
6. Remove the software feature key (dongle) from the defective server, and then install
it in the replacement server (see Replacing the software feature key on page 86).
7. Remove the hard drive from the defective server, and then install it in the
replacement server (see To remove the hard drive on page 83).
8. Install the replacement server on the switch, and then reconnect the peripherals.
9. Boot the server to the operating system.
10. Run the Configuration Wizard to configure the new hardware.
For instructions, see the CallPilot <switch model> and CallPilot Server
Configuration guide for your switch and server.
202i server component diagram
The following diagram shows a completely assembled 202i server.
What is next?
Avaya CallPilot 202i Server Maintenance and Diagnostics December 2010 81