Avaya 4524GT, Руководство по настройке

Страница: 93 / 362

save config
The
save config
command is in the exec command mode.
The
save config
command has no parameters or variables.
Automatically downloading a configuration file
Enable this feature through ACLI by using the
configure network
and
script load-
on-boot
command. Use these commands to immediately load and run a script and to
configure parameters to automatically download a configuration file when the switch or stack
is booted.
Important:
When you use the TFTP address parameter to perform copy or download commands, the
system overwrites the TFTP server address
The syntax for the
configure network
command is
configure network load-on-boot {disable | use-bootp | use-config}
address <XXX.XXX.XXX.XXX> filename <name>
Table 28: configure network parameters on page 93 outlines the parameters for this
command.
Table 28: configure network parameters
Parameter Description
load-on-boot {disable | use-bootp |
use-config} The settings to automatically load a configuration file
when the system boots:
• disable: disable the automatic loading of config file
• use-bootp: load the ASCII configuration file at boot
and use BootP to obtain values for the TFTP
address and file name
• use-config: load the ASCII configuration file at boot
and use the locally configured values for the TFTP
address and file name
Important:
If you omit this parameter, the system immediately
downloads and runs the ASCII configuration file.
address <XXX.XXX.XXX.XXX> The IP address of the TFTP server.
filename <name> The name of the configuration file to use in this
process
Configuration files in ACLI
Configuration — System April 2011 93