Avaya 4524GT, Руководство по настройке

Страница: 126 / 362

• Setting PoE detection method on page 128
• Show port power status on page 128
• Show port power measurement on page 129
Set port power enable or disable
Use the
poe-shutdown command
to disable PoE to a port.
The syntax for the poe-shutdown command is
poe poe-shutdown [port <portlist>]
Use the
no poe-shutdown
command to enable PoE to a port.
The syntax for the
no poe-shutdown
command is
no poe-shutdown [port <portlist>]
In either command, substitute
<portlist>
with the ports on which PoE is enabled or
disabled.
Run the
poe-shutdown
and
no poe-shutdown
commands in Interface Configuration
command mode.
Set port power priority
The
poe-priority
command sets the port power priority.
The syntax for the
poe-priority
command is
poe poe-priority [port <portlist>] {critical | high | low}
Table 44: poe-priority parameters on page 126 outlines the parameters for this command.
Table 44: poe-priority parameters
Parameter Description
port <portlist> The ports to set priority for
{low | high | critical} The PoE priority for the port
Run the
poe-priority
command in Interface Configuration command mode.
System configuration using ACLI
126 Configuration — System April 2011