Avaya 4524GT, Руководство по настройке

Страница: 141 / 362

Variables Description
Important:
If you omit this parameter, the system uses the port number
you specified in the interface command.
10|100|1000|auto Set the speed to:
• 10: 10 Mb/s
• 100: 100 Mb/s
• 1000: 1000 Mb/s or 1 GB/s
• auto: autonegotiation
Important:
Enabling or disabling autonegotiation for speed also enables or disables it for duplex
operation.
When you set the port speed for autonegotiation, ensure that the other side of the link is
also set for autonegotiation.
default speed command
The
default speed
command sets the port speed to the factory default speed.
The syntax for the
default speed
command is
default speed [port <portlist>]
Run the
default speed
command in Interface Configuration command mode.
The following table describes the parameters for this command.
Table 58: Default speed variables
Variables Description
port <portlist> Specify the port numbers for which to set the speed to factory
default. Enter the port numbers to set.
Important:
If you omit this parameter, the system uses the port number
you specified in the interface command.
duplex command
The
duplex
command specifies the duplex operation for a port.
General switch administration using ACLI
Configuration — System April 2011 141