Avaya 4524GT, Руководство по настройке

Страница: 137 / 362

Run the
no ip default-gateway
command in Global Configuration command mode.
Important:
When you change the IP gateway, connectivity to Telnet and the Web Interface can be
lost.
show ip command
The
show ip
command displays the IP configurations, BootP mode, stack address, switch
address, subnet mask, and gateway address. This command displays these parameters for
what is configured, what is in use, and the last BootP. The sub command,
Display DNS
configuration
, provides information about the DNS configuration.
The syntax for the
show ip
command is
show ip [bootp] [default-gateway] [address]
Run the
show ip
command in User EXEC or Privileged EXEC command mode.
If you do not enter any parameters, this command displays all IP-related configuration
information.
The following table describes the variables for the
show ip
command.
Table 53: show ip parameters
Variables Description
bootp BootP-related IP information.
default-gateway The IP address of the default gateway.
address The current IP address.
Assigning and clearing IP addresses for specific units
You can use ACLI to assign and clear IP addresses for a specific unit in a stack. For details,
see the following sections:
• ip address unit command on page 137
• no ip address unit command on page 138
ip address unit command
The
ip address unit
command sets the IP address and subnet mask of a specific unit in
the stack.
General switch administration using ACLI
Configuration — System April 2011 137