Avaya 1408, Руководство по установке

Страница: 137 / 144

PARTNER Version Installation Manual Page 137
- Issue 1c (09 April 2010) IP Office Essential Edition
Safety Statements: Lightning Protection/Hazard Symbols
8.2 Trunk Interface Modules
To ensure the validation of the approvals, only the following types of trunk interface cards must be fitted in the following
IP Office control units.
USA/Canada
Product PRI E1 PRI T1 ATM4 WAN
Single Single
IP Office Essential Edition -
PARTNER® Version
8.3 Further Information and Product Updates
Further information, including Product and Reference Manual updates, can be obtained from Avaya's Dealers and
Distributors, or from Avaya's web site:
http://www.avaya.com .
This guide is also available from the Avaya's support web site: http://support.avaya.com .
Support Telephone Numbers
For initial help and support, contact your distributor/supplier. The following contact points are for Avaya authorized
partners.
·
In the USA only
Avaya provides a toll-tree Customer Helpline 24 hours a day:
·
Name: Avaya Technical Support Organization (TSO)
·
Customer Helpline: 1 800 628-2888
·
Address: 8744 Lucent Blvd., Highlands Ranch, Colorado, 80129 USA
·
URL: http://support.avaya.com
If you need assistance when installing, programming, or using your system, call the Helpline or your Avaya
representative. Consultation charges may apply.
·
Outside the USA
If you need assistance when installing, programming, or using your system, contact your Avaya representative.
·
URL: http://support.avaya.com
8.4 Compliance with FCC Rules
Transmit and Receive Gain Settings for PRI/T1 and Analog Ports
The Gain settings are password controlled for use by qualified installation personnel only and must not be made available
to the end user. The default gain settings of 0dB ensures compliance with FCC part 68 section 68.308(b)(5) and TIA/EIA-
IS-968 Section 4.5.2.5. "Through transmission amplification from ports for the connection of separately registered
equipment or from other network connection ports". Gain setting adjustment by unqualified personnel may result in
violation of the FCC rules. Qualified personnel may adjust gain settings above these levels only where:
1. Measurement is made to ensure that the power levels sent to line at each network interface connected does not exceed
the maximum levels specified in FCC part 68 section 68.308(b) and TIA/EIA-IS-968 Section 4.5 for that specific
interface type.
2. Where gain adjustment away from the default values are made, precautions should be taken to ensure that the
connection of terminal equipment is controlled by qualified installation personnel.