OPERATION TIME PROGRAMMING FOR TWO LEAFED SWINGING GATE WITHOUT SLOW SPEED
Set trimmer
TORQUE
at minimum needed to move the door leaf correctly and adjust trimmer
for slow
speed at maximum needed to move the door leafs correctly.
Totally close the door.
Press
for at least 3 seconds.
TEST LED
starts blinking.
Release
Press
START:
The first leaf starts moving at normal speed.
When first leaf is totally open press
START:
The second leaf starts opening at normal speed.
When the second leaf is totally open press
START:
The second leaf starts closing at normal speed.
When the second leaf is totally closed press
START:
The first leaf starts closing at normal speed.
Press
START:
the first leaf starts opening and when you decide that the time interval between the opening of
the two leafes is enough press
START
again
:
The second leaf starts opening.
Press
START:
The second leaf starts closing and when you decide that the time interval between the closing of
the two leafes is enough press
START
again
:
The first leaf starts closing.
Wait until the
TEST LED
turns off.
The operation time programming is complete.
The next time the door will open will be according to the settings just completed.
ATTENTION:
After RESET or power supply failure, at the first closing of the door the operation time will be greater
(approximately 12 seconds)
PROGR
PROGR
SLOW
M2
M1
M2
M1
1
START
2
START
M2
M1
2
START
M2
M1
4
START
M2
M1
5
START
M2
M1
6
START
M2
M1
7
START
M2
M1
8
START
M2
M1
9
START
First START command initiates
the operation time programming
causing the first motor to OPEN.
Third START command defines
the end of first motor operation time
and must be issued when the door
totally opens.
Third START command defines
the end of the second motor
operation time and must be issued
when the doors totally opens.
Fourth START command defines
the end of the second motor
operation time and must be issued
when the door totally closes.
Fifth START command defines
the end of the first motor operation time
and must be issued when the door
totally closes.
Sixth START command initiates
the programming for the operation time
interval between the
two leafs of the door when opening.
Seventh START command starts the
second motor after the desired time interval
between the opening of the two motors.
Eighth START command initiates
the programming for the operation time
interval between the two leafs
of the door when closing.
Ninth START command starts the
first motor for the operation time interval
between the two leafs of the door
when closing
6
