SETTINGS
Through micro(DIP) switches 4,5,7 and 8 the following settings may be applied.
Dip switch
OPERATION
ON
OFF
4
Preflashing
Enabled
Disabled
5
Revert movement
Enabled
Disabled
7
Lighting operation
LIGHT
BEACON
8
Max torch at closing ending Enabled
Disabled
ADJUSTABLE TRIMMER
TR1
adjusts auto close time (the time the door remains open before closes automatically),with range from
1 to 120
seconds.
TR2
adjusts motor torch. For motors with clutch or hydraulic oil pressure you must set
TR2
to maximum (that is one full turn
to the right).
TR3
adjusts door speed at slow motion mode, which can be set according to safety parameters. By setting
TR3
to maximum
(that is one full turn to the right) slow speed is disabled. (see. Operation time programming without slow speed).
Trimmer Operation Range
Special Functions
TR1
Auto Close
1 – 120 seconds
-
TR2
Motor Torch 20 – 100 %
100 % ( Hydraulic or clutched motors)
TR3
Slow Speed
10 – 100 %
100 % = Slow Speed Disabled
REMOTE CONTROL PROGRAMMING
AT-8070-D control board has a built in receiver that can store upt o 128 Rolling coded remote controls or one fixed coded
remote control.
Remote control programming for total door open
If the door is closed, press RADIO and hold it until TEST LED starts blinking. Release RADIO and within 10 seconds, press
the remote control you want to program. When the procedure is completed TEST LED and the FLASHING LIGHT must turn
ON ant then OFF simultaneously. For rolling coded remote controls repeat procedure for each control. For Fixed coded
remote controls just copy the remote controls.
Remote control programmin for pedestrian
When the door is closed press
until
TEST LED
starts blinking. Do not relase
TEST LED
starts blinking faster.
Realease
RADIO
. Within 10 seconds, press the button of the remote control you want to program.
When the procedure is completed TEST LED and the FLASHING LIGHT must turn ON ant then OFF simultaneously.
For rolling coded remote controls repeat procedure for each control. For Fixed coded remote controls just copy the remote
controls.
Erase all remote controls
When the door is closed press
RADIO
and hold it until
TEST LED
starts blinking. Do not relase
TEST LED
until it starts
blinking faster. µέχρι το
TEST LED.
When all remote controls are erased from memory TEST LED and the FLASHING LIGHT
must turn ON ant then OFF simultaneously.
MAINTENANCE
There are two 5 Χ 20 fuses for the 230Vac line and the low voltage that is supplied from the transformers secondary coil. The
fuses have the following values
F1
Line Fuse 230Vac = 6,3 Slow burning
F2
Low Voltage Fuse = 1,25 A Slow burning
Prior to replacing the fuses the
power supply must be turned off from the main electrical supply.
The value of the fuses must not be altered.
There is no other element on the control board that can be repaired or replaced from installation
personnel. For any other issue contact technical support.
RADIO
230Vac
4
