INTRODUCTION
AT-8070-D
control board is suitable for two 230VAC actuators for single or double swinging gate.
The max absorption of the device is 650 W per 230Vac 50Hz.
The setup of the parameters must be carried out after the installation of all the equipment.
ATTENTION
The Product must be installed by qualified personnel who can carry out the installation operation strictly in
compliance with safety rules. The device must not be used incorrectly or for any purposes other than the
ones designed for. Before proceeding with the installation it is necessary to read the instruction manual
carefully in order to avoid danger to either the users or the equipment. It is necessary to power the device
using a 6A bipolar thermomagnetic switch equipped with a differential with an operating current of 0.03 A.
Before currying out any installation or maintenance operations turn off the power supply to the device with
the bipolar switch. The equipment must not be tampered with or modified in any way. it is necessary to turn off
the power supply to the equipment before installing it or opening the enclosure.
The manufacturer reserves the right to make changes to the product without prior notice. Therefore
this manual may not correspond exactly to the product specifications.
AT-8070-D Control Board for swinging gates
DESCRIPTION
P1A
= Operating time programming button
P2B
= Remote control programming button
DSW1
= Micro Switches
TR1, TR2, TR3
= Adjustable trimmers
RESET
= Reset Button
F2
= Low Voltage Fuse
TF1
= Transformer
CN1
= Receiver
M1
= Low Voltage Input Terminal
F1
= 230Vac Fuse
M2
= 230Vac Input Terminal
K1 – K3
= Relay
2
EN60950
EN301489-1
EN301489-3
EN300220-3
Radio & Telecommunications Terminal Equipment directive 1999/5/EC
AUTOTECH - G .KAPSALIS
8, Archimidous str. 12134 Peristeri Athens,
Greece, Tel: +302105780019, Fax: +302105785112
In accordance with the following directives:
DECLARATION OF CONFORMITY
hereby declare that:
Product : AT8070 Remote Control Board for Opening Doors
Model : AT-8070-D
is in conformity with the applicable
requirements of the following documents.
I hereby declare that the equipment named above has been designed to
comply with the relevant sections of the above referenced specifications.
The unit complies with all the applicable essential requirements of the
directives mentioned.
Name:
Apergis Antonios
Position: Technical Director
Peristeri, 28 November 2013
F2
TR1
TR2
TR3
P1A
P2B
CN1
M1
F1
M2
K1
K2
K3
TF1
RESET
