SECTION 1 - SAFETY INFORMATION
1.1 Important Safety Instructions
When installing and using this electrical equipment, basic safety precautions should always be
followed, including the following:
READ AND FOLLOW ALL INSTRUCTIONS.
l
A green colored terminal or terminal marked G, GR, Ground, Grounding, or the
symbol is located inside
the power center terminal box or compartment. To reduce the risk of electric shock, this terminal must be
connected to the grounding means provided in the electric service panel with a continuous copper wire
equivalent in size to the circuit conductors supplying this equipment.
l
Follow all state, local, and National Electrical Code(s) (provincial and Canadian Electrical Code(s) if
applicable) unless local guidelines supersede.
l
For personal safety, and to avoid damage to equipment, follow all safety instructions displayed on the
equipment and within this manual. Repair and service of your AutoPilot
®
chlorinator must be performed by
qualified service personnel.
l
Should you suspect your chlorine generator is not performing properly, refer to the Troubleshooting section in
this manual to determine if service is required.
See "Troubleshooting" on page 31.
l
Warranties will be voided if the chlorinator has been improperly installed. Failure to properly operate, maintain
or repair the AutoPilot
®
chlorinator will void the factory warranty.
SAFETY SIGNALS
Throughout this manual safety signals are placed where particular attention is
required.
WARNING - Failure to heed the following may result in permanent injury or
death.
CAUTION - Failure to heed the following may result in equipment damage.
WARNING - Failure to heed the following may result in permanent injury or death.
l
RISK OF ELECTRICAL SHOCK - Disconnect all AC power when installing or servicing this system. Follow
all state, local, and National Electrical Code(s) (provincial and Canadian Electrical Code(s) if applicable)
unless local guidelines supersede. Use copper conductors only.
l
RISK OF ELECTRICAL SHOCK - To reduce the risk of electrical shock, replace damaged cord
immediately.
l
RISK OF ELECTRICAL SHOCK - The AutoPilot
®
chlorinator contains no owner-repairable components.
Repairs must not be attempted by untrained and / or unqualified individuals. If service is deemed necessary,
contact installing dealer or AquaCal AutoPilot Customer Support.
l
RISK OF ELECTRICAL SHOCK - A bonding lug has been provided on the outside of the power supply. This
lug
permits
the
connection
of
a
No.
8
AWG
(8.4
mm
2
)
solid
copper-bonding
conductor
(No.
6
AWG
in
Canada).
Make
this
connection
between
the
Pool
Pilot
®
power
supply
and
all
other
electrical
equipment
and
exposed
metal
within
5
ft
(1.5
m)
of
the
unit.
All
field-installed
metal
components
(such
as
rails,
ladders,
drains,
etc.)
within
10
ft
of
the
pool,
spa,
or
hot
tub,
must
be
bonded
to
the
equipment
grounding
bus
using
copper
conductors
not
smaller
than
No.
8
AWG
(8.4
mm
2
)
(No.
6
AWG
in
Canada).
Install
control
center
at
least
10'
(3
m)
from
the
inside
wall
of
the
pool
or
spa
using
non-metallic
plumbing.
l
RISK OF ELECTRICAL SHOCK - A disconnect device incorporated into the fixed wiring must be included in
the supply circuit (such as a time clock, relay, or circuit breaker).
l
RISK OF ELECTRICAL SHOCK - Connect only to a branch circuit protected by a ground-fault circuit-
interrupter (GFCI). Contact a qualified electrician if you cannot verify that the circuit is protected by a GFCI.
Содержание Pool Pilot Professional PPP-2
Страница 2: ......
