Automatismos Pujol SPIDER PRO 600, Инструкция по установке и настройке

Страница: 25 / 28

automatismos pujol -
7
- english
SPIDER PRO 600
memorising the remote controls for operation in «Total opening» mode fig. 25
The remote controls supplied in the kit have already been memorised.
It is possible to memorise up to 32 control channels.
If this procedure is carried out using a channel which has already been memorised, this channel will be cleared.
SPECIfIC OPERaTION
See the user booklet.
ClEaRING ThE REmOTE CONTROlS aND all SETTINGS
Clearing the remote controls
fig. 26
Press button “ B ” until the light flashes (7 secs).
Causes all memorised remote controls to be cleared.
Reinitialising all settings
fig. 27
[1]. Press button “ a ” 3 times to access the auto-programming parameter.
[2]. Press button « B ” to enter auto-programming mode. Warning light B flashes twice continuously.
[3]. Control the motor with button “ a ” so that the transmission shuttle is engaged on the carriage and brings the door to the closed position.
[4]. Press “ B ” to launch the auto-programming cycle.
The door performs a complete Opening-Closing cycle.
- If the auto-programming is correct, warning light B goes out.
-
If the auto-programming cycle was not successful, warning light B flashes twice continuously.
REfITTING ThE COvER flaP
(fig. 28)
Fit the cover flap.
DIaGNOSTICS
Warning light B meaning Solution?
2
Motor waiting for auto-programming Start auto-programming
3
Cell fault Check that no obstacles prevent the cells from detecting.
Check the wiring of the cells or create a bridge between
terminals 1 and 2 if no cells are installed.
Check the correct alignment of the cells.
5
Motor thermal protection device Leave the motor to cool until the fault disappears.
6
Motor current measuring circuit fault or sensor fault Switch off the power supply (mains and backup battery), wait
a few minutes then reconnect the power supply.
Perform an auto-programming cycle. If the fault remains,
contact automatismos pujol technical assistance.
7
Maximum power delivered by the motor reached during the
auto-programming phase
Product has reached operating limit.
https://appceso.com