AutomationDirect IronHorse HGR-37-005-A, Руководство пользователя

Страница: 24 / 38

Page 3–4 IronHorse® Helical Gearbox User Manual – 1st Ed. Rev. B
Chapter 3: Installation, Maintenance and Lubrication
Mounting Positions
M1
M4
M3
M5 M6
M2*
*NOTE: Mounting position M2 is not permitted.
Starting Up
1) Check oil level before starting up See the Lubrication section for instructions on proper unit
lubrication
2) Run In Procedure - IronHorse helical gearboxes do not require a run in procedure; however, the
oil should be changed after the first 300 hours of operation
Inspection and Maintenance
Please check the oil quality and change it regularly.
1) The oil should be changed after the first 300 hours of use After that, the oil should be changed
every 2500 hours or 6 months, whichever occurs first
2) Regularly inspect all seals for leaking
3) During regular operation, listen for excessive noise
4) Regularly check the breather valve holes of the helical gearbox and make sure all openings are
unclogged and free of debris The exterior of the helical inline unit should be kept clean The
unit housing dissipates heat and must be kept free of debris to reduce heat buildup
5) Check installation bolts regularly and tighten as required
6) Any parts used should be equivalent to the original factory standards When parts are used, a
running test should be conducted without a load before the unit is returned to operation
7) This equipment requires regular maintenance Keep a log of oil changes and bolt tightening
Log any equipment issues and all corrective actions taken for warranty records