AutomationDirect IronHorse HGR-37-005-A, Руководство пользователя

Страница: 23 / 38

Installation, Maintenance and Lubrication
Page 3–3 IronHorse® Helical Gearbox User Manual – 1st Ed. Rev. B
Installation
Improper installation will cause damage to the helical gearbox. Please familiarize yourself
with the entire set of installation instructions before starting installation.
1) Clean all dirt from the surface of the shaft or flange before installation During cleaning, be
careful not to get cleaning solvents on any seals as cleaning solvents may damage the seals and
void product limited warranty
2) The helical gearbox can be placed in any of five install positions
M1, M3, M4, M5 or M6 Position M2 is not permitted See MOUNTING POSITIONS for the
definition of mounting positions
3) The helical gearbox should be installed on a stable foundation
The installation location should provide good air ventilation for the unit and allow for
convenience of oil filling/ draining for proper ongoing unit maintenance
Foundation flatness specifications
Mounting footprint length ≤ 230 – 01mm
230 < Mounting footprint length ≤ 440 – 02mm
440 < Mounting footprint length ≤ 500 – 04mm
500 < Mounting footprint length ≤ – 06mm
4) IronHorse helical gearboxes are designed to be connected to NEMA frame motors The
connection to the motor is a quill style mount Please note that some flange sizes will extend
below the base of the helical gearbox
5) After the installation, please turn the input shaft manually to avoid a dead-lock condition
6) The unit is shipped with a vent plug in the filler location for mounting positions M1 and M3 If
required, move the vent plug to the filter location as shown on the following page
7)
If the vent plug is white plastic, remove the red pin before operating the gearbox If it is brass,
pull of the upper portion of the rubber strap as shown below
Plastic vent plug
Brass vent plug Brass vent plug - readied for use