Automation Direct D0-DEVNETS, Руководство пользователя

Страница: 18 / 78

Installing the DeviceNet
Slave Module
Installation and
Safety Guidelines
2–7
Installing the D0–DEVNETS Slave Module
D0–DEVNETS DeviceNet Slave
Module User Manual, Rev A
Configure the Adapter
Use the software of your DeviceNet master to configure the controller for your
network.
Refer to the software Help file and/or manual for help with configuration.
Follow these basic steps when configuring your D0–DEVNETS adapter.
1. Set the Adapter Node Address:
In the DeviceNet master software, make sure the adapter node address is
set to an available node number on the DeviceNet network (from 0 to 63).
2. Add the EDS file (if required by the software):
In your DeviceNet software, add the D0–DEVNETS Electronic Data Sheet
(EDS) file from the disk which came with this manual or from our web site
www.automationdirect.com . Some software may not provide for the use
of EDS files.
3. Commission the Node:
Use the DeviceNet software to “Commission the Node” of the adapter.
Again, some software may not require this.
4. Add the D0–DEVNETS to the Scan List:
Add the D0–DEVNETS to the Scan List in your DeviceNet Master software.
5. Set the Input/Output Bytes:
If required by your DeviceNet software, set the I/O Parameters to Tx =
Output bytes and Rx = Input bytes, for Polled I/O.
Follow the steps in
Appendix G to determine the actual number of Output and Input bytes your
system has.
6. Map the I/O to the Master:
Map the D0–DEVNETS I/O to the Scanner using Auto Map, or map the I/O
to another location if desired.
7. Scan:
Go Online (or Scan) to verify the configuration and check for errors.
8. View Indicators on the adapter:
Refer to the Status Indicators when connecting to the network.
Configuring the
DeviceNet Adapter