ATS Series Installation Manual
14
15. Coding a Transmitter
15.1 Storing the Transmitter Code
The opener can only operated from remote control
transmitters that have been programmed into its
memory. Up to 64 codes can be stored in the memory.
a. Press the MODE button repetitively until the
TRANSMIT
LED is lit.
b. Press and HOLD the button/s indicated in the table
to set the required transmitter function. The Main
light will start to flash rapidly.
c. Press one of the four (4) buttons on the transmitter
until the main light starts to flash rapidly, then release
transmitter button.
d. Press the remote control button again until the main
light stops flashing rapidly.
e. Release both buttons. The transmitter button is now
coded, press to test.
NOTE: Refer to the Light indicator table for the details
of the transmitter status.
BUTTON
TRANSMITTER
FUNCTION
Open / Stop / Close
HOLD
PET (Pedestrian) Mode
HOLD
Open
HOLD
Light
HOLD
HOLD
Vacation Mode
HOLD
HOLD
MAIN LIGHT
TRANSMITTER
STATUS
ON
Button added
OFF
Button removed
2 FLASHES, then OFF
Remote control deleted
4 FLASHES, then OFF
Memory full
15.2 Installation of the Wall Mounted
Transmitter
a. Store the transmitter code as per instructions
above. Test the transmitter button.
b. Mount the transmitter in a convenient location, yet
out of reach of children and at least 1.5m off the
ground.
c. Make sure the door is visible from this location.
15.5 Remotely Coding Transmitters
Using this method transmitters can be coded without access to
the opener’s control panel as long as a pre-coded transmitter is
available.
a. Take any pre-coded transmitter. Press the button for the
function to be duplicated and release.
b. Using a small needle / pen, press and hold firmly for two
seconds the middle button, through the Coding Hole.
c. Within ten (10) seconds take the additional transmitter you
wish to code. Hold the new transmitter’s button for two
seconds, pause for two seconds, hold again for two seconds
and then release.
d. Wait for ten (10) seconds and then press the new transmitter’s
button to test.
15.3 Erasing All Transmitter Codes
a. Press the MODE button repetitively until the TRANSMIT
LED is lit.
b. Press and hold the MODE button for 10 secs, let the MODE
button go when the main light stops flashing.
c. Follow steps a - e in Storing the Transmitter Code to code
new transmitters.
15.4 Vacation Mode
a. To turn on Vacation mode and lock out all remotes, press the
button on the remote programmed with Vacation Mode.
b. To turn off Vacation Mode, press the transmitter button
programmed to vacation mode to turn off.
