ATS Series Installation Manual
13
14. Auto-Close
WARNING! It is compulsory to have
Safety Beams installed when using
Auto-Close mode.
Parameter
Value options = Indicated by brightness of
main light (DEFAULT parameter underlined)
Name
Flashes
1
2
3
4
5
6
PE AUTO-CLOSE
2
OFF
15sec
30sec
60sec
90sec
-
AUTO-CLOSE
3
OFF
15sec
30sec
60sec
90sec
120sec
Auto-Close mode is a function that automatically closes the door after
a pre-set time. Safety beams must be installed in order to run the Auto-
Close function. There are two types of Auto-Close available:
i. Standard auto-close - the door will Auto-Close after a
programmed time. In this mode the timer starts to countdown
as soon as the door is fully open. This function is useful in case
the safety beam does not get triggered.
ii. Safety Beam triggered auto-close - the door will auto-close
after a programmed time. In this mode the timer starts counting
down only when the safety beam is triggered. ie car leaving the
garage.
To enable the Auto-Close function:
a. Press the MODE button repetitively until the GEAR
LED starts
flashing.
b. Press the OPEN button
until the GEAR
LED flashes:
i. two (2) times to get to PE auto-close or
ii. three (3) times to get to standard auto-close.
c. Press STOP / SET button to enter parameter.
d. The default setting for Auto-Close is OFF. Press the OPEN button
to move through options and the light’s brightness will change
accordingly.
e. Press STOP / SET button to save the parameter’s new value or press
MODE to leave the value unchanged.
