Owner Installation Instructions
Easy Slider - Sliding Gate Opener
31
Remote code set procedure
�� � � �
If a transmitter is already coded into the opener,
additional transmitters can be coded without being in
direct contact with the opener’s control panel.
NOTE:
Only the function of the existing transmitter
button can be assigned to new transmitter. Please read
instructions prior to proceeding - there is a time-out
facility for security reasons.
1. Selecting the function to be coded
Using the existing transmitter, operate the gate with the
transmitter button which has the function to be coded
(Fig. 55)
(e.g. Button 1 has been coded with the OSC
function assigned).
2. Wait for gate to complete cycle
If the button’s function activates the gate (PED, SWP,
OSC, CLS, STP or OPN) wait for the gate to complete
its cycle.
3. Activate remote code set mode
Using a small pin press and hold through the Coding Hole
of the existing transmitter for two seconds
(Fig. 56).
4. Code new transmitter button
Within 10 seconds, press the button on the new
transmitter you wish to code for 2 seconds
(Fig. 57)
.
5. Confirm transmitter button to be coded
Press the same button again (within 10 seconds)
for confirmation.
6. Test operation
The new transmitter button should now function as the
existing transmitter.
NOTE:
When a transmitter is remote coded, its ID label
is set to that of the existing transmitter. If the existing
transmitter does not have an ID label assigned, then
the ID label of the new transmitter is set to: R/C Tx ###,
where ### is the existing transmitters store number.
This ensures that the originator of any remote coded
transmitter can be identified.
�� � � �
55
fig
57
fig
56
fig
Existing
transmitter
New
transmitter
