POWERING UP THE CONTROLLER
After checking the initial wiring, apply power to the CB-19. The
controller will go through a startup sequence displaying the
STARTUP SCREEN which indicates the controller type and
firmware version. After a short delay the MAIN SCREEN will be
displayed. If this is the first time the controller has been used, the
MAIN SCREEN should indicate that the limits are not set. If the
display shows that some input is active then rectify the situation
before proceeding. If a default setting is to be changed it should
be done now beforing setting the travel limits.
A.T.A
CB19
Firmware
#.##
STARTUP SCREEN
7
SETUP TRAVEL
This section shows how to set the travel limits for drive units with limit switches. The procedure can be partly completed using
a remote control transmitter as a remote console. In order to use a remote control transmitter it must first have at least one of
its buttons coded to the controller’s receiver. The function assigned to the transmitter's buttons is of no concern here as the
buttons are temporally assigned to OPEN, CLOSE and SET. Refer to TRANSMITTER OVERVIEW.
Note: The limit setting procedure can be aborted at anytime by pressing EXIT.
STEP 1. NAVIGATING TO “LIMIT/AMP TRAVEL MENU”
To navigate to the Menu 10.1 from the MAIN SCREEN simply
press PREVto display MENU 10, followed by SET to display
MENU 10.1. Press SET again to start the limit setting procedure
STEP 2. CONFIRMING READY TO START.
The CB-19 will prompt you to confirm that the motor wiring is
complete and that the gate(s) are in a halfway position and
engaged. Press SET to confirm.
The CB-19 can be used with drive units that use different methods to stop at the end of their travel.
The types supported are:
A) Limit switch. Open and close limit switches indicate to the controller when the travel limit is reached.
B) AMP trip limits. Travel limits are detected by and an increase in motor current as mechnical stops are reached.
C) Timing. The motor is driven for a preset time. When the travel limit is reached a clutch incorporated into the drive
unit allows the motor to keep turning for the remaining preset running time.
The setup proceedure for each type of drive unit follow.
LIMIT SWITCH / AMP TRAVEL SETUP
MENU
10.1
Limit/AMP
Travel
PRESS
Selecting Limit/AMP Travel Setup
PRESS
Confirming Wiring Is Completed
PRESS
Selecting Limit/AMP Travel Setup
Motor
Wiring
Completed?
Half
Open
Gate
&
Engage
Mtrs,
SET
MAIN SCREEN
Limits
Not
Set!
P
Pr
re
es
ss
s
<
<>
>
t
to
o
A
Ac
cc
ce
es
ss
s
M
ME
EN
NU
US
S
