Automatic Systems
Logic D1 v06-02-en0802.doc
ERB-PM
Technical manual
14/31
EXAMPLE:
Programming of the non-passage time-out (parameter 2) to 60 seconds:
1.
Note the existing operation mode parameters of the logic board.
2.
Set DIP 1 to 8 of SW4 (
1:15
) to
OFF.
3.
Set DIP 8 to
ON.
4.
The red LED LD2 (
1:17
) flashes slowly.
5.
Set the number of the parameter 2 with the DIP switches in binary mode: DIP 2 to
ON.
6.
Press
PGM
, the push button SW5 (
1:16
) to enter the number.
7.
The red LED LD2 (
1:17
) flashes quickly.
8.
Set the value of 60 (seconds) in binary mode: DIP 3, 4, 5 and 6 to
ON.
9.
Press
PGM
, SW5 (
1:16
).
10.
The red LED LD2 (
1:17
) flashes slowly.
11.
Return DIP 1-7 to
OFF
.
12.
To stop the programming, set DIP 8 to
OFF
.
13.
Set the operation mode parameters as noted in point 1.
2.4.4.
Resetting the parameters by default
Proceed as follows to reset the parameters to default:
1.
Switch off the power supply of the logic board.
2.
Push on the
PGM
button SW5 (
1:16
) and maintain it depressed all along the process.
3.
Switch on the power supply of the logic board.
4.
The red LED LD2 (
1:17
) lights on
5.
Release the
PGM
button (
1:16
) when the red LED LD2 has lit off.
1 2 3 4 5 6 7 8
1 2 4 8 16 32 64 0
ON
OFF
1 2 3 4 5 6 7 8
1 2 4 8 16 32 64 0
ON
OFF
