AUTO
CRIB
1.
Swing the door back and forth to loosen the spring
2.
Look to see if the plunger is aligned with the door latch. If the
alignment is off, adjust the door up or down depending on how
the door shifted during shipment.
3.
While the doors are closed, there should be an equal amount of
space between the top and bottom of each door.
SWITCH DEFINITIONS
MP
= MAIN PLATTER
LSP
= LARGE SUB PLATTER
SSP3 = SMALL SUBPLATTER #3
SSP2 = SMALL SUB PLATTER #2
SSP1 = SMALL SUB PLATTER #1
9. Assuming this is a master RoboCrib, the Management Station and RoboCrib have been pre-
configured for a peer-to-peer network. Therefore, it is important to complete the setup of
the management station before starting the Robocrib computer.
a.
Locate the “Quick Start” form in the software packet provided with the management
station. Use this form to begin the setup of the management station. .
b.
Upon startup of the management station, Carbon Copy and the Autocrib software will
start.
c.
Exit the Autocrib software.
d.
Place the database file sent to you in the C:\Program Files\Autocrib folder. (You may
have received a zipped file. This will require use of the WinZip software.)
e.
Restart the Autocrib software.
f.
Connect the cat 5 cable from the management station’s Ethernet port to a port in the
hub provided. Once this connection has been made, the corresponding light on the hub
should be lit. (
These instructions are based on a peer-to-peer configuration. If the
customer’s network is being used for the installation, the network administrator may
need to be contacted
.)
g.
Connect the cat 5 cable from the RoboCrib’s Ethernet port to an available port in the
hub. Once this connection has been made, the corresponding light on the hub should
be lit.
h.
Start the RoboCrib computer.
8
