AUTO
CRIB
b.
Enter your Employee ID and PIN .
c.
Select the item you wish to return by either scrolling down, or typing in the Item Code
or Description of the item. Press “Enter”.
d.
When the return dispatch screen appears, type in the quantity being returned in the
appropriate field (i.e. Return, Scrap, Regrind).
e.
Place the inventory in the correct return location (Regrind bin, Active RoboCrib Bin, or
Trash).
f.
Note: An item can only be returned to the RoboCrib if the crib has been designated as
“returnable” in the AutoCrib software and the item being returned is a
perishable/durable item.
8.
Locate an Item in the RoboCrib or another crib in the AutoCrib System.
a.
Press the
“Locate”
button.
b.
Type in an Item Code or Partial Description of the item you wish to Locate.
c.
The system will Filter the database to the closest possible matches.
d.
Select the item and the Crib and Bin number will be displayed as well as the current on
hand inventory.
9.
Troubleshooting the RoboCrib using the “Maintain” Button.
a.
Press the
“Maintain”
button.
b.
Type in the your Employee ID and PIN . You must have “Supervisor” level access
indicated in your employee detail record in the AutoCrib software.
c.
To call a bin, type FET BBB P (B is for Bin Number, P is for Baffle Position). Ie.
FET 21 L 3. This will call bin 21L and set the baffle position for a fourth pie.
d.
Baffle Positions (P) are as follows:
i.
(1) = twelfth pie
ii.
(2) = sixth pie
iii.
(3) = fourth pie
iv.
(4) = third pie
v.
(5) = half or full pie
e.
Once the bin has been positioned in front of the doors, you must call the door. LON
DD (D is for Door Number). Ie. LON 15. This will open door 15.
f.
An invalid bin number will return an error (E2). If the tray configuration is unknown,
please refer to the numbering scheme provided at the time of installation.
g.
Other commands that can be used:
i.
RSA (Report Status All): If system is calibrated and all doors are
closed, the system will report back “OK”. If a door is open, the system
will report back “DO”.
ii.
TST M or TST L: moves the main platter or LSP one complete
clockwise revolution.
iii.
CAL M or TST L: moves the main platter or LSP one complete counter
clockwise revolution.
iv.
To view more controller commands, please reference Appendix I.
18
