AUTO
CRIB
b.
Manually rotate the Main Platter with your hands until you have access to the LSP
motor.
c.
Drive the motor back shaft (see diagram below) until you are able to access the correct
tray assembly or small platter motor.
If you are unable to get platters to
move. You may take a cordless
drill, gently chuck on the motor
back shaft and drive the motors until
you have moved the desired bin to
the access location. This is helpful
in the event of a power outage.
6.
Bin Door will not open
a.
The Bin Door must be removed.
b.
Manually pop the door by pushing on the solenoid shaft.
c.
Check the alignment of the doors.
d.
Clean out any debris found inside the door.
e.
Check the wiring connection.
f.
Make sure the other doors work.
g.
Replace a non-functioning assembly with a known good assembly.
7.
Replacement of Controller
a.
Remove the Right Front panel section so that the display and controller are accessible.
b.
Disconnect the door wiring, motor wiring, sensor wiring (on top of controller), the
DB9 cable and the power cable from the PC.
c.
Remove the six screws that hold the control panel to the vertical Z channels.
8.
The chain needs to be remounted because it has broken or come off of the gears.
a.
Position the platters at their home position, column 111.
b.
Through the holes in the LSP, align the threaded holes in the Main Platter.
c.
Lock the LSPs to the Main Platter with ¼-20 bolts.
d.
Loosen the motor mounts and reinstall the chain.
e.
Tighten the motor mounts, remove the bolts, and adjust the tension.
20