Auto-Sleepers Gloucester2010, Руководство пользователя

Страница: 70 / 118

9-14
FITTED EQUIPMENT
Changing the batteries on the automatic
igniter
If sparking is inaudible, or takes place at
intervals of more than a second, the battery
needs replacing.
Replace batteries only when the heater is
switched off. Insert a new battery before the
start of the heating season. (Battery type e.g.
Ever Ready Type AA).
Raise the battery compartment cover and
replace battery. Pay attention to plus/minus
signs. Close compartment cover.
Important Operating Notes
If the gas supply line is full of air, it may take
up to a minute before the gas is available for
combustion. During this time, hold the control
knob in depressed position until the flame
ignites.
You will have to find out the exact thermostat
setting yourself, depending on how much
heat you need and the way your vehicle is
designed.
The thermostat probe is underneath the
heater.
Note: The thermostat will be adversely
affected by cold draughts from refrigerator
vents, gaps below doors, etc. Always make
sure to avoid problems of this kind, otherwise
satisfactory temperature control cannot be
guaranteed.
WARNINGS:
1. Under floor combustion, air intakes
must be kept clear of dirt and foreign
matter and should be regularly
checked accordingly.
2. In winter, before switching on the
heater, clear all snow from the cowl.
3. Inspect the exhaust duct and all
connections at regular intervals, and
always whenever there is a blowback.
4. Never allow the warm air outlet on the
heater to be obstructed in any way.
For instance, never hang washing on
or in front of the heater to dry.
Misusing your heater in this way could
cause serious damage from
overheating. Do not place flammable
objects near the heater. Please follow
these guidelines in the interest of your
own safety.
Cleaning (with switched off appliance)
It is recommended that at least once a year,
before the season starts, you remove any
dust that has collected on the heat
exchanger, base plate and fan impeller wheel
of the Ultraheat warm air system. The fan
impeller must be cleaned carefully using a
brush or toothbrush. You will need to remove
the heater casing. To do this pull forward at
the fold out casing or pull the casing forward
at the top, lift it up until it is loose, and then
remove it from the installation box.
General Safety Notes
• Repairs must only be carried out by an
approved Truma engineer.
• Attention: A new O-ring must always be
installed after dismantling the exhaust
duct.
Any alteration to the appliance (including
exhaust duct and cowl) or the use of spare
parts and accessories which are important to
the function of the heater and which are not
original Truma parts, as well as the non-
observance of the installation and operating
instructions, will lead to the cancelling of the
guarantee and exclusion of liability claims. It
also becomes illegal to use the appliance,
and in some countries, this even makes it
illegal to use the vehicle.