Auto-Sleepers Gloucester2010, Руководство пользователя

Страница: 65 / 118

9-9
FITTED EQUIPMENT
Control Panel (gas operation)
GAS OPERATING INSTRUCTIONS
WARNING: Never operate the water heater
without water in it.
Remove cowl cover (press upper centre with
both thumbs and pull from the top of cover
towards you).
Open gas cylinder and open isolation tap in
the gas supply line.
Select required water temperature at rotary
knob (b), which is infinitely variable from
approximately 30 to 70 deg C.
Switch on water heater at the slide switch (a)
on the control panel, the green indicator lamp
“Operation” then lights up.
If there is air in the gas supply line, it may
take up to a minute before the gas is
available for combustion. If the appliance
switches to “Failure” during this period,
switch off the appliance - wait two minutes -
and switch on again.
Switching Off (gas operation)
Switch off the water heater at the slide switch
(a).
WARNING: Drain the water heater is there
is a risk of frost.
If the water heater is not to be used for a long
period, fit the cowl cover. Non-observance of
this point can lead to the operation of the
a = Rotary switch ON - “gas operaton”
b = Rotary switch OFF
c = Rotary knob for temperature selection
(illuminated by green lamp “Operation”
d = Red indicator lamp “Failure”
appliance being impaired through water, dirt
or insects. Close the isolation tap in the gas
supply line and turn off the gas cylinder.
No warranty claim will be met if this point is
not observed. Always remove the cowl cover
prior to operating the water heater.
Red Indicator Lamp “Failure”
The red indicator lamp (d) lights up if there is
a failure.
The reason for such an indication is, for
example, if no gas is available or if there is
air in the gas supply system, triggering the
excess temperature monitor. To unlock,
switch off the appliance, wait 5 minutes, and
switch on again.
In the event of faults, always contact Truma
Service (they may be contacted through your
local Auto-Sleeper dealer or direct on (01283)
528201).
ELECTRICAL OPERATING
INSTRUCTIONS
WARNING: Never operate the water heater
without water in it.
Locate the mains isolator switch in the under
kitchen cupboard. Push the rocker switch
down to turn on the electrical heating. Don’t
forget to switch off when no longer required.
Note: The water temperature is fixed at
approximately 70 deg C. For a faster heating
up period the appliance can be
simultaneously operated on both gas and
electrical power.
Note: The water tank in the Truma Ultrastore
is of high quality stainless steel. The plastic
elbow water connections and the safety/drain
valve fulfil the EC guidelines for food quality
in plastic parts (90/128/EEC).
In order to avoid the colonization of micro
organisms, Truma recommend heating up the
tank to 70 deg C at regular intervals and not
using the water as drinking water.