Auto-Sleepers Gloucester2010, Руководство пользователя

Страница: 48 / 118

7-22
CONNECTION OF SERVICES
Leisure Battery
Dangerously Low
Vehicle Battery
Dangerously Low
PSU Over Temp
Cooling Down
System disabled
Engine started
5 Operational & Safety Information
5.1 Connecting to the Mains supply - Safety checks
For your safety it is IMPORTANT that you follow these connections instructions each time your
Leisure Vehicle is connected to a mains supply.
A) Ensure suitability of the Mains Supply . Your Leisure Vehicle should only be connected to
an approved supply that meets the requirements of BS7671. In most cases the site warden
will hold information regarding suitability of supply. If using a generator you also need to
comply with the requirements /instructions supplied with the generator. Please note that
some electronic generators may not be compatible with your leisure system.
B) Switch the EC325PSU internal Power Converter OFF . Locate the green ‘Charger’ power
switch on the EC325PSU and ensure the switch is in the OFF (0) position before connection
to the mains supply.
C) Connect the Hook-up Lead . Firstly connect the supplied hook-up lead (orange cable with
blue connectors) to the Leisure Vehicle and then connect to the mains supply.
D) Check Residual Current Device operation . Locate the RCD within the EC325PSU and
ensure the RCD is switched on (lever in up position). Press the ‘TEST’ button and confirm
that the RCD turns off (lever in down position). Switch the RCD back to the on position (lever
in up position). If the test button failed to operate the RCD see section 5.2.
E) Check correct Polarity . Locate the ‘Reverse Polarity’ indicator on the EC325PSU and
ensure that the indicator is NOT illuminated. If the indicator is illuminated see section 5.2.
F) Check Miniature Circuit Breakers . Locate the MCB’s within the EC325PSU (adjacent to
the RCD) and ensure they are all in the ON (up) position. If any MCB’s fail to latch in the on
position see section 5.2.
G) Turn the EC325PSU ON . Locate the green power switch on the EC325PSU and turn to the
ON (I) position. The switch will illuminate when turned on.
H) Check operation of equipment . It is now safe to check the operation of the 12v and 230v
equipment.
You can switch over to the
leisure battery immediately (and
cancel the beep) by using the
battery selector switch.
See section 3.7 for further
details.
This warning is unlikely to occur
under normal operation. If your
PSU does overheat please
check the ventilation slots for
blockages etc.
EMC (Electro Magnetic
Compatibility) directive 89/336/
EEC requires that electrical
accessories within the vehicle
are disconnected while the
vehicle is in motion.
This WARNING display indicates that the
vehicle battery voltage is low (10.9 volts or
less). The panel will beep for one minutes
and then switch over to the leisure battery to
prevent draining the vehicle battery.
This WARNING display indicates that the
leisure battery voltage is low (6 volts or less).
The panel will beep for one minute and then
switch the power off to prevent damage to
the leisure battery.
This WARNING indicates that the
EC325PSU has overheated and is cooling
down. The charger and power converter will
shutdown to allow the cooling fan to reduce
the heat of the PSU.
This WARNING display indicates that the
system has been disabled because the
vehicle engine is running.
4.5 Warning Messages