AUTHOR Alarm IGLA, Руководство по обслуживанию

Страница: 29 / 48

26
4. If the IGLA ALARM has already been set up in a car
and the KEYLESS BLOCK has not yet, transfer them
into the alignment mode having fulfilled the next
steps:
• turn on the ignition without starting the engine;
• sign in using the PIN-code;
• push the accelerator to the floor and keep it pushed;
• repeat the PIN-code;
• release the accelerator when the first indication
flashes have started emerging (once in three seconds);
If the current PIN-code involves slight push of the
accelerator, enter the PIN-code once again and
after that press the accelerator to the floor.
• twist the red and the gray wires of the KEYLESS
BLOCK together and supply a «Plus» to it.
The system will proceed to the alignment mode.
Successful alignment will be confirmed by a double
indication signal. Turn off the ignition and disconnect
the gray wire.
5. If both of the devices have not been still set up in
a car:
• connect the gray and the red wires of the IGLA ALARM
to a permanent «Plus» and turn on the ignition;
• twist the red and the gray wires of the KEYLESS
BLOCK together and supply a «Plus» to it.
The system will proceed to the alignment mode.
Successful alignment will be confirmed by a double
indication signal. Turn off the ignition and disconnect
the gray wire.
!