with the module being tested. The most common cause is
that the scanned module is not supported on the vehicle.
z
The numbers (01, 02, 15, 03, 08, etc) in front of the system
names refer to the physical addresses assigned to the systems,
not the sequence of the systems to be arranged.
8)
Select
Read Codes
from the
Select Function
menu and press the
Y
button.
Select Function
►
1) Read Codes
2) Erase Codes
3) ECU Information
4) Readiness Test
z
If there are no Diagnostic Trouble Codes present, the display
will indicate “
NO CODES ARE STORED IN THE
MODULE!”
z
If there are any Diagnostic Trouble Codes present, the DTC
number and its definition will show on the LCD display.
z
The subcode, the communication protocol, the sequence of
the DTC currently being observed and the total number of
codes detected will be observed on the upper right hand
corner of the display.
z
When a DTC’s definition covers more than one display screen,
use the
Y
button, as necessary, to view any additional
information.
z
If the DTC definition is not available, an advisory message
prompting you to refer to the vehicle service manual will be
observed on the display.
z
If more than one DTC is found, use the
UP/DOWN
scroll
buttons, as necessary, until all the codes have been shown up.
11
