Installation and operation manual
IMPORTANT! B (insulation stripping length) is 2-3mm longer than A (OT cable
terminal crimping area)
4. Insert the stripped wire into the OT terminal crimping area, and use the hydraulic clamp to
crimp the terminal to the wire as shown in the figure below.
IMPORTANT! After crimping the terminal to the wire, inspect the connection to
ensure the terminal is solidly crimped to the wire.
5. Remove the screw from the heat sink ground point.
6. Use the screw of the ground point to attach the grounding cable to the heat sink. Tighten
the screw securely. Torque is 10-12Nm (as shown as in Figure 5.9).
M-S2-OX-EN-V2.4
23
