Auerswald COMmander Basic.2, Инструкции по установке и вводу в эксплуатацию

Страница: 68 / 84

Connection Options
68
Setting up a Dial-up Connection on Windows 7
Steps to Take
1.
Click Start.
2.
Click Control Panel.
3.
Click Network and Internet.
4.
Click Network and Sharing Center.
5.
Click Set up a new connection or network.
6.
Click Set up a dial-up connection and click Next.
7.
Remote configuration: Under Dial-up phone
number, enter the remote switching number
(including city code and exchange line access
number) on the PBX.
Configuration via the internal S
0
port: Under Dial-up
phone number, enter the internal CAPI dial-in
access number on the PBX.
8.
Under User name, enter “admin” and under
Password, enter the admin PIN on the PBX.
Or: Under User name, enter “external” and under
Password, enter the external PIN on the PBX.
Or: Under User name, enter the internal telephone
number of a sub-admin, and under Password, enter
the associated sub-admin PIN.
9.
Under Connection name, enter any connection
name, for example, “PBX + [customer name]” and
click Connect.
10.
Click Close.
Enabling the PBX for Remote Configuration
Requirements
– Internal telephone for the PBX
– Existing authorisation “Controlling the PBX via tele-
phone”
Steps to Take
1.
Pick up the receiver.
2.
Enter the following series of numbers:
## 8 PIN
*
91 #
Note: The PIN can be, in this case, a sub-admin PIN
or the user PIN that belongs to the telephone.
You will then hear the confirmation tone
(pulsating tone).
3.
Hang up the receiver.
Note: You usually dial in using the remote switching
number on the PBX. If the remote switching number
has not been configured and the PBX has been
enabled, it is accessible over each associated MSN/
DDI.