auer 151201, Инструкция по установке и эксплуатации

Страница: 7 / 84

-
INSTALLER
HIGH-TEMPERATURE ENERGY EFFICIENT HEAT PUMP
MANUAL
-
7
2.3 - Accessories (included)
The components described below are included with the Pilot but
they are not pre-assembled:
Outdoor temperature sensor
2 core sheathed cable linking the
Heat Pump and the Pilot (lgth10m)
It is pre-fi tted to the Heat Pump, but needs connecting to the
Pilot
Hydraulic connection kit
lgth 1.5m
2.4 - Accessories available to order
Interactive room temperature sensor
enables you to
control the temperature of the heating zone it is installed in
(
Ref. 751009
)
Underfl oor heating temperature
limiter (UTL) at 65°C with manual
reset
for underfl oor heating installations.
The jubilee clips and cables are included.
(
Ref. 710111
).
2 core sheathed cable for linking the Heat Pump
and
the Pilot
(lgth 20m)
To be used instead of the 10m-long cable which is included
with the appliance (
Ref. 751005
)
Non chrono-proportional wireless room
thermostat -TH Rnc -
(Type on/off ). Programmable thermostat with wireless radio
frequency transmission (
Ref. 710172
). Needed when it is not
possible to wire a link between the Pilot and room thermostat.
Anti-frost element
Used to prevent frost from forming on the inside of the
condensates pipe. (
Ref. 751004
)
2
nd
direct heating circuit
(radiators)
Including inlet and outlet pipes, circulator pump and wiring
(
Ref. 751003
)
2 nd heating circuit with motorised 3-way valve
(underfl oor heating)
Including inlet and outlet pipes, 3-way motorised valve,
circulator pump, electronic control with 3WV leaving water
and outdoor temperature sensors, room temperature
corrector and underfl oor heating temperature limiter (UTL)
(
Ref. 751007
)
Optional control kit for swimming pools in
summer
enabling you to substitute a swimming pool on
circuit 1 in summer for the heating which runs on it in winter.
(
Ref. 751006
)
DHW or swimming pool sensor
(
Ref. 710029
)
1 ’’ valve
with (500μm) built-in fi lter which is used to
protect the Heat Pump’s plated heat exchanger
Cap
which enables you
to access the filter
when the valve is
closed
1’’ check valve
Between the HRC7
0
Heat Pump and the
HRC 70 Pilot