USER’S MANUAL / bit Tune /
70
2.
- Choose
Auto Time Alignment
from the main menu of the PC Software,
if you want to perform the automatic calibration of the system’s time delays.
3.
The system will ask if you want to perform a phase measurement of the system’s
speakers (Polarity Check) via the
LPM
microphone, placed near the speakers.
- Choose
YES
to perform a phase measurement of the speakers
- Choose
NO
to skip this operation if it was already performed earlier.
- Choose
Don’t ask me again
, to cancel the request for future measurements.
4.
The system will ask if you want to measure the levels of the system’s speakers
(Level Check) via the
LPM
microphone positioned as shown in fig. 1,2.
- Choose
YES
to perform the measurement of the speakers’ levels
- Choose
NO
to skip this operation if it was already performed earlier.
- Choose
Don’t ask me again
, to cancel the request for future measurements.
5.
Place the
HSM
microphone in the fastening bracket on the headrest corresponding
to the listening point chosen on the system’s
Channel Map
.
- Select one of the available processor memories for saving the measurement settings.
- Click
Start
to start the measurement. This may take several minutes.
- Click
Cancel
to quit the measurement.
7
1.
Connect the bit Tune to the Audison bit processor, as shown in fig. 1, 2 or 3 (see points
A, B
and
C
).
The AUTO TIME ALIGNMENT procedure must be performed in an environment that is not noisy,
with the car’s engine off, air conditioning off, doors and windows tightly closed and radio frequency
devices away from the car’s passenger compartment.
- Turn the
bit Tune
on and connect the USB cable to the PC.
- Set the function switch of the
bit Tune
on
PC ANALYZER
.
- Turn on the Audison bit processor and connect the USB cable to
the
bit Tune
.
- Start the
bit Tune
software by clicking the icon on the PC desktop
and launch the software in
bit Tune + Processor
mode.
A. bit Ten:
Connect the
AUX Left
and
Right
inputs of the
bit Ten
to
the
Pre Out Left
and
Right
outputs of the bit Tune, and set the
level of the
AUX
inputs to position 1.
B. bit One:
Connect the
AUX1 Left
and
Right
inputs of the
bit One
to the
Pre Out Left
and
Right
outputs
of the
bit Tune
.
C.
AP bit:
connect the Aux input to the L-R outputs of the bit Tune, ensuring that the AUX input is enabled. If
you want to connect the bit Tune to AP bit amplifiers to perform measurements, but the AUX input port is
already occupied, you can use the OPTICAL input
.
Содержание bit Tune
Страница 1: ...USER S MANUAL rev 2 2 audison com ...
