USER’S MANUAL / bit Tune /
56
5.
At the end of the speaker’s phase measurement procedure the following symbols
may appear on the channel map:
- The green indicates that the speaker is wired in phase. Repeat the measurement
for the other speakers in your system by repeating step 4. Once the phase measurements
on the system’s speakers close the
Polarity Check
window.
- The red symbol: indicates that the speakers are not wired in phase. Work on the
wiring of the speakers or amplifiers, bringing them back in phase with the audio system,
or proceed with the measurement of the phases.
- A message indicating that the level of the measurement signal is
too low. In this case, repeat from step 3, raising the level by 5 dB.
- A message indicating that the level of the measurement signal is too high.
In this case, repeat step 3 lowering the volume by 5 dB.
Note:
The speakers’ phase information will be automatically saved in the final Report of the measurement session.
7
Содержание bit Tune
Страница 1: ...USER S MANUAL rev 2 2 audison com ...
