CHAPTER 5 Cabling the Device
MP-1288 | Hardware Installation Manual
Connecting FXS Interfaces using Centronics Cable
You can purchase AudioCodes' Centronics-type cable connector, as shown in the following
figure, to connect the FXS interfaces to FXS equipment. The 10-meter cable (32.8 ft.) provides a
50-pin male Telco connector on one end and open leads on the other end, which need to be
connected to your patch panel or distribution frame.
Figure 5-12: Orderable Centronics Cable and Pinouts
➢
To connect the FXS interfaces using the Centronics cable:
1.
Connect the 50-pin male connector on end of the cable to one of the FXS blade's 50-pin
female Telco connectors located on the chassis' rear panel, and secure the connector with
the two captive screws located on either side of the connector, using a Philips screwdriver:
Figure 5-13: Connecting 50-Pin Telco Connector to Port on FXS Blade
- 28 -
