CHAPTER 5 Cabling the Device
MP-1288 | Hardware Installation Manual
Figure 5-1:
Stripped Grounding Wire
2.
Using a Philips-head screwdriver, remove the two screws and their spring washers for
attaching the grounding lug, located on the chassis' rear panel as shown in the following
figure:
Figure 5-2:
Removing Screws and Washers
3.
Insert one end of the grounding wire into the grounding lug (supplied), as shown in the
following figure, and then use a crimping tool (not supplied) to secure the wire to the
grounding lug:
Figure 5-3:
Attaching Grounding Wire to Grounding Lug
4.
Attach the grounding lug (supplied) to the chassis using the two screws.
5.
Attach the grounding lug to the chassis, as shown in the following figure. Make sure that
the spring washers are located between screw head and lug.
Figure 5-4:
Attaching Grounding Lug to Chassis
- 20 -