AudioCodes Mediant 2000, Руководство пользователя

Страница: 230 / 418

SIP User's Manual 230 Document #: LTRT-68808
Mediant 2000
•
'No': The device is 'locked' regardless of traffic. Any existing traffic is terminated
immediately.
Note:
These options are only available if the current status of the device is in the
Unlock state.
3.
In the 'Lock Timeout' field (relevant only if the parameter 'Graceful Option' in the
previous step is set to 'Yes'), enter the time (in seconds) after which the device locks.
Note that if no traffic exists and the time has not yet expired, the device locks.
4.
Click the
LOCK
button; a confirmation message box appears requesting you to
confirm device Lock.
Figure 3-98: Device Lock Confirmation Message Box
5.
Click
OK
to confirm device Lock; if 'Graceful Option' is set to 'Yes', the lock is delayed
and a screen displaying the number of remaining calls and time is displayed.
Otherwise, the lock process begins immediately. The 'Current Admin State' field
displays the current state: LOCKED or UNLOCKED.
¾
To unlock the device, take these 2 steps:
1.
Open the 'Maintenance Actions' page (refer to ''Maintenance Actions'' on page 228 ).
2.
Under the 'LOCK / UNLOCK' group, click the
UNLOCK
button. Unlock starts
immediately and the device accepts new incoming calls.
3.5.1.3.3 Saving Configuration
The 'Maintenance Actions' page allows you to save (
burn
) the current parameter
configuration (including loaded auxiliary files) to the device's
non-volatile
memory (i.e.,
flash). The parameter modifications that you make throughout the Web interface's pages
are temporarily saved (to the
volatile
memory - RAM) when you click the
Submit
button on
these pages. Parameter settings that are only saved to the device's RAM revert to their
previous settings after a hardware/software reset (or power failure). Therefore, to ensure
that your configuration changes are retained, you must save them to the device's flash
memory using the burn option described below.
¾
To save the changes to the non-volatile flash memory , take these
2 steps:
1.
Open the 'Maintenance Actions' page (refer to ''Maintenance Actions'' on page 228 ).
2.
Under the 'Save Configuration' group, click the
BURN
button; a confirmation message
appears when the configuration successfully saves.