AudioCodes Mediant 2000, Руководство пользователя

Страница: 177 / 418

Version 5.6 177 November 2008
SIP User's Manual 3. Web-Based Management
2.
From the 'Routing Index' drop-down list, select the range of entries that you want to
add.
3.
Configure the Tel to IP Routing table according to the table below.
4.
Click the
Submit
button to save your changes.
5.
To save the changes to flash memory, refer to ''Saving Configuration'' on page 230 .
Table 3-44: Tel to IP Routing Table Parameters Description
Parameter Description
Tel to IP Routing Mode
[RouteModeTel2IP]
Determines whether to route Tel calls to IP before or after
manipulation of destination number.
ƒ
[0]
Route calls before manipulation = Tel-to-IP calls are routed
before the number manipulation rules are applied (default).
ƒ
[1]
Route calls after manipulation = Tel-to-IP calls are routed after
the number manipulation rules are applied.
Notes:
Not applicable if outbound Proxy routing is used.
Src. Trunk Group ID
[PREFIX_SrcTrunkGroupID]
The source Trunk Group for Tel-to-IP calls.
The range is 1-99.
Notes:
ƒ
If this parameter is not required in the routing rule, leave the field
empty.
ƒ
To denote any Trunk Group, you can enter the asterisk (*)
symbol.
Dest. Phone Prefix
[PREFIX_DestinationPrefix]
Represents a called telephone number prefix. The prefix can be 1 to
19 digits long. An asterisk (*) represents all numbers.
Source Phone Prefix
[PREFIX_SourcePrefix]
Represents a calling telephone number prefix. The prefix can be 1 to
19 digits long. An asterisk (*) represents all numbers.
All Tel calls matching all or any combination of the above routing rules are subsequently sent to the
destination IP address defined below.
Notes:
ƒ
For alternative routing, additional entries of the same prefixes can be configured.
ƒ
For notations representing multiple numbers, refer to ''Dialing Plan Notation'' on page 168 .
Dest. IP Address
[PREFIX_DestAddress]
The destination IP address (in dotted decimal notation) to where
these calls must be sent. Domain names (e.g., domain.com) can be
used instead of IP addresses.
Notes:
ƒ
If you select a destination IP Group (in the 'Dest IP Group ID' field
below), then the IP address you define in this 'Dest IP Address'
field is not used for routing and therefore, not required.
ƒ
To discard outgoing IP calls of a specific Tel-to-IP routing rule,
enter 0.0.0.0. For example, if you want to prohibit dialing of
international calls, then in the 'Dest Phone Prefix' field, enter 00
and in the 'Dest IP Address' field, enter 0.0.0.0.
ƒ
For routing calls between phones connected to the device (i.e.,
local routing), enter the device's IP address. When the device's IP
address is unknown (e.g., when DHCP is used), enter the IP
address 127.0.0.1.