AudioCodes Media Pack MP-112, Руководство пользователя

Страница: 451 / 486

Version 5.8 451 September 2009
SIP User's Manual 10. Networking Capabilities
On startup, the device sends a STUN Binding Request. The information received in the
STUN Binding Response (IP address:port) is used for SIP signaling. This information is
updated every user-defined period (NATBindingDefaultTimeout).
At the beginning of each call and if STUN is required (i.e., not an internal NAT call), the
media ports of the call are mapped. The call is delayed until the STUN Binding Response
(that includes a global IP:port) for each media (RTP, RTCP and T.38) is received.
To enable STUN, perform the following:

Enable the STUN feature(by setting the ini

Define the STUN server address using one of the following methods:
file parameter EnableSTUN to 1).
•
Define the IP address of the primary and the secondary (optional) STUN servers
(using the
ini
•
Define the domain name of the STUN server using the
file parameters STUNServerPrimaryIP and
STUNServerSecondaryIP). If the primary STUN server isn’t available, the device
attempts to communicate with the secondary server.
ini

Use the
file parameter
StunServerDomainName. The STUN client retrieves all STUN servers with an
SRV query to resolve this domain name to an IP address and port, sort the server
list, and use the servers according to the sorted list.
ini file parameter NATBindingDefaultTimeout to define the default NAT binding
lifetime in seconds. STUN is used to refresh the binding information after this time
expires.
Notes:
•
STUN only applies to UDP (it doesn’t support TCP and TLS).
•
STUN can’t be used when the device is located behind a symmetric NAT.
•
Use either the STUN server IP address (STUNServerPrimaryIP) or
domain name (STUNServerDomainName) method, with priority to the
first one.
10.2.2 First Incoming Packet Mechanism
If the remote device resides behind a NAT device, it’s possible that the device can activate
the RTP/RTCP/T.38 streams to an invalid IP address / UDP port. To avoid such cases, the
device automatically compares the source address of the incoming RTP/RTCP/T.38 stream
with the IP address and UDP port of the remote device. If the two are not identical, the
transmitter modifies the sending address to correspond with the address of the incoming
stream. The RTP, RTCP and T.38 can thus have independent destination IP addresses and
UDP ports.
You can disable the NAT mechanism by setting the ini file parameter DisableNAT to 1. The
two parameters EnableIpAddrTranslation and EnableUdpPortTranslation allow you to
specify the type of compare operation that occurs on the first incoming packet. To compare
only the IP address, set EnableIpAddrTranslation to 1, and EnableUdpPortTranslation to 0.
In this case, if the first incoming packet arrives with only a difference in the UDP port, the
sending addresses won’t change. If both the IP address and UDP port need to be
compared, then both parameters need to be set to 1.