AudioCodes Media Pack MP-112, Руководство пользователя

Страница: 304 / 486

SIP User's Manual 304 Document #: LTRT-65412
MP-11x & MP-124
Parameter Description
For example:
TargetOfChannel 0 = 1002,1; (phone number "1002" is automatically
dialed for Port 1)
TargetOfChannel 1 = 101,1; (phone number "101" is automatically dialed
for Port 2)

Define this parameter for each device port that implements Automatic
Dialing.
Notes:


After a ring signal is detected on an 'Enabled' FXO port, the device
initiates a call to the destination number without seizing the line. The
line is seized only after the call is answered. After a ring signal is
detected on a 'Disabled' or 'Hotline' FXO port, the device seizes the
line.
This parameter can appear up to 8 times for MP-118-port and up to 24
times for MP-124 devices.

For configuring this table using the Web interface, refer to ''Configuring
Automatic Dialing''
143 on page .

For an explanation on using ini file table parameters, refer to ''Format of
ini File Table Parameters'' 191 on page .
6.8.11 Direct Inward Dialing Parameters
The Direct Inward Dialing (DID) parameters are described in the table below.
Table 6-43: DID Parameters
Parameter Description
Enable DID Wink Enables Direct Inward Dialing (DID) using Wink-Start signaling.
[EnableDIDWink]

[0]

Disable = Disables DID Wink(default).
[1]
If enabled, the device can be used for connection to EIA/TIA-464B DID
Loop Start lines. Both FXO (detection) and FXS (generation) are
supported. An FXO interface dials DTMF digits after a Wink signal is
detected (instead of a Dial tone). An FXS interface generates the Wink
signal after the detection of off-hook (instead of playing a Dial tone).
Enable = Enables DID Wink.
Delay Before DID Wink Defines the time interval (in msec) between detection of off-hook and
generation of a DID Wink.
The valid range is 0 to 1,000. The default value is 0.
[DelayBeforeDIDWink]
Note:
This parameters is applicable only to FXS interfaces.
Determines the type of Direct Inward Dialing (DID) signaling support for
NTT (Japan) modem: DTMF- or Frequency Shift Keying (FSK)-based
signaling. The devices can be connected to Japan's NTT PBX using
'Modem' DID lines. These DID lines are used to deliver a called number
to the PBX. [NTTDIDSignallingForm]

[0]

= FSK-based signaling (default)
[1] = DTMF-based signaling
Note: This parameter is applicable only to FXS interfaces.