AudioCodes Media Pack MP-112, Руководство пользователя

Страница: 147 / 486

Version 5.8 147 September 2009
SIP User's Manual 3. Web-Based Management
Parameter Description
Note: If this field only contains a telephone number and a Proxy isn't
used, the 'forward to' phone number must be specified in the 'Tel to IP
Routing' table (refer to ''Configuring the Tel to IP Routing Table''
131
on page
).
If you have set the 'Forward Type' for this port to 'No Answer', enter the
number of seconds the device waits before forwarding the call to the
phone number specified. Time for No Reply
Forward
3.3.4.9.5 Configuring Caller ID Permissions
The 'Caller ID Permissions' page allows you to enable or disable (per port), the Caller ID
generation (for FXS interfaces) and detection (for FXO interfaces). If a port isn't configured,
its Caller ID generation/detection are determined according to the global parameter
EnableCallerID described in ''Configuring Supplementary Services'' on page
114 .
Note: You can also configure the Caller ID Permissions table using the ini file table
parameter EnableCallerID.

To configure Caller ID Permissions per port:
1. Open the 'Caller ID Permissions' page ( Configuration tab > Protocol Configuration
menu > Endpoint Settings submenu > Caller ID Permissions
Figure 3-86: Caller ID Permissions Page
page item).
2. From the 'Caller ID' drop-down list, select one of the following:
•
'Enable': Enables Caller ID generation (FXS) or detection (FXO) for the specific
port.
•
'Disable': Caller ID generation (FXS) or detection (FXO) for the specific port is
disabled.
•
Not defined: Caller ID generation (FXS) or detection (FXO) for the specific port is
determined according to the parameter 'Enable Caller ID' (described in
''Configuring Supplementary Services''
114 on page ).