Power supply
TV Sound Stand
GB
54
CUSTOMER SERVICE
www.gt-support.de
00800 - 45622000
GB
9.
POWER SUPPLY
Inserting/changing the battery of the remote control
DANGER!
There is a danger of explosion if the battery is not correctly replaced.
Replace only with the same or an equivalent type.
NOTE:
the remote control is supplied with an inserted battery. Pull the plastic strip out
of the remote control before using it for the first time.
A Phillips screwdriver is required for this.
1. Release the small screw on the underside of the
remote control with a Phillips screwdriver.
2. Pull out the battery compartment.
3. Insert the battery (CR2025 3V) or replace the old
battery with a new one. The positive pole (+) of
the battery must point upwards.
4. Slide the battery compartment back into the
remote control and tighten the screw again.
Power supply connection
1.
Connect all devices before you connect the power supply.
2.
Insert the flat end of the mains plug into the connector
AC 230 V ~ 50 Hz
on the device.
3.
Insert the mains plug into a readily accessible power socket whose voltage
matches the voltage stated on the rating plate. The power socket must still be
easily accessible after connection.
NOTE:
to disconnect the device from the mains pull out the mains plug out of the pow-
er socket.
_TVS264_2018_Soundstand_AudioAffairs.book Seite 54 Donnerstag, 30. August 2018 9:17 09
