12/33
3.4 Parameter setting mode
00000000000000000000
00000000000000000000
Smkr 137 Food 122
Set 250 Probe3 270
00000000000000000000
00000000000000000000
> Cont ro l Sett i ng
System Con f i g
SET
Press & Hold
Figure 16. Access the menu of parameter setting mode using SET key.
Press and hold the SET key for about 2s to enter parameter setting mode. For details,
please check section 5.
4. Operation
All cooking profile settings and control parameters can both be accessed from the device
and AuberWIFI app (for WIFI model only).
4.1 Set the Cooking Profile
The controller’s cooking profile can be either set to multi-step mode (default) or
single-step mode. In the multi-step mode, up to 6 steps can be programmed. Each step
has its own set temperature for cabinet probe (Probe 1) and its step-ending criterion. A
cooking step can either end by timer or by food internal temperature (Probe 2). In the
single-step mode, the controller will try to maintain the cabinet temperature at the set
value of Step 1 (“Step 1 SmkrTemp”) as long as the controller is on. To switch between
single-step mode and multi-step mode, please check section 4.1.3.
4.1.1 Multi-Step Mode
A total of 6 steps can be programmed on this controller. Each program step comprises a
target temperature of cabinet (shown as “SmkrTemp: XXX”) and an ending criterion
setting “
X-Ending
”, where “X” is the step number. For example, “
1-Ending
” means the
ending criterion of
Step 1
. The “ending criterion” is a new concept to people who never
used Auber’s controllers. It determines how a cooking step is considered finished. Two
options are available: time and food internal temperature (Probe 2). If you want
Step X
to
end after a pre-set time period, set “
X-Ending
” by “
Time
”; if you want
Step X
to end
when food internal temperature reaches a pre-set value, set “
X-Ending
” to “
Fd Temp
”.
After you set “
X-Ending
” to “
Time
”, you will need to set “
X-Time
”. Here, “
X-Time
” is
defined as the time duration (in hh:mm format) of the current step. The timer will start
counting even if the cabinet temperature has not yet reached the target cabinet
temperature. So, please make sure that the step time is long enough. If the step time is
too short, the controller may continue to the next step no matter what the actually cabinet
temperature is. If you set “
X-Ending
” to “
X-Fd Temp
”, you will need to set “
X-Fd Temp
”
to the desired food temperature (Probe 2), but only one setting is relevant to the current
