10
■
Precautions for Charging
The desktop holder, specified charger (sold separately) and optional
accessories are not waterproof/dustproof. Be sure to check the
following before and after charging.
•
Check that there is no water drop or foreign object on the product. If
a foreign object is adhered to the product, wash it away immediately.
In addition, if the product is wet, drain water well and wipe it with a
dry, clean cloth, etc. before inserting the microUSB plug into the
external connection jack.
•
Never connect the microUSB plug when the product or specified
charger (sold separately) is wet or a foreign object is adhered to it.
Although the product is waterproof and dustproof, the specified
charger (sold separately) is not waterproof or dustproof. If the
microUSB plug is inserted while the product or charger is wet or dirty,
water or a foreign object on the product or microUSB plug might
cause electric shock, short circuit or corrosion, resulting in abnormal
overheating, burnout, fire, burns or a fault.
•
Do not touch the desktop holder or specified charger (sold
separately) with wet hands. Doing so might cause electric shock.
•
Do not expose the desktop holder, specified charger (sold separately)
or optional accessories to water. Do not use them in places where
water is regularly used, such as a bathroom, shower room, kitchen
and washroom. Doing so might cause fire, burns, electric shock, a
fault, etc. In addition, do not bring them into such places even if you
are not using them for charging. Doing so might cause fire, burns,
electric shock, a fault, etc.
■
Washing the Product
If stain, dust, sand, soft drink, etc. is adhered to the surface of the
product, gently wipe it off with a cloth and wash the product under a
low-pressure flow of tap water (up to 6 liters/min) at room temperature
(5
°
C to 35
°
C) approximately 10 cm away from the faucet or shower
head.
When washing the sliding part of the camera slide cover, shake the
product under fresh water in a container with the cover open.
Holding the au Nano IC Card 04/microSD memory card closed, wash
the product with your hands without using a brush or sponge. After
washing the product, drain water and then use the product.
•
Make sure that the au Nano IC Card 04/microSD memory card cover
is securely closed before washing the product.
•
Do not wash the product in a washing machine or ultrasound bath.
•
The earphone/microphone jack and external connection jack are
especially susceptible to dust, sand and other particles. Wash it away
thoroughly. After washing it away, make sure the jacks are dried off
before using the product. Any residue in the jacks may cause a fault.
•
When cleaning the earphone/microphone jack or external connection
jack, do not use tools such as a cotton swab or push a cloth into the
jack. Doing so might cause impairment of the waterproof and
dustproof properties, resulting in fire, burns, or a fault.
•
Never put the product in a microwave oven for drying it. Doing so
might cause the internal battery to leak, overheat, burst or ignite. In
addition, it might cause the product to overheat, emit smoke or
ignite, or destroy its circuit components.
•
Do not expose the product to hot air from a hair dryer or leave it in a
high temperature environment for drying it. Doing so might cause the
product to deform, discolor, malfunction, etc.
■
Draining Water
If the product is wet, be sure to drain water from the earphone/
microphone jack, external connection jack, earpiece (receiver)/speaker,
mouthpiece (microphone), sub microphone, keys (Power key, Volume
up/down key, Shutter key, Phone key, Home key, Mail key), camera
slide cover, air vent, etc.
1
Wipe off water on the surface of the product
thoroughly with a dry, clean cloth, etc.
If a strap is attached, dry it sufficiently as well.
2
Hold the product securely and shake it
approximately 20 times until there is no more
water splashing
Check the safety of your surroundings; while shaking the product,
hold it securely so as not to drop it.
Mouthpiece
(microphone)
External
connection jack
Earpiece (receiver)/
speaker
Volume up/
down key
Shutter key
Earphone/
microphone jack
Sub microphone
Power key
Phone key,
Home key, Mail key
Camera slide cover
Air vent
3
Pat the product against a dry, clean cloth, etc. to
remove moisture from the grooves
Water may be trapped in the openings; put a cloth against them
and pat the product to remove the water. Make sure that there is
no water or foreign object left in the openings.
4
Leave the product on a dry cloth, etc. for
approximately 2 to 3 hours at room temperature to
dry it
After wiping off the water, water remaining in the product may seep
out, if any.
Do not wipe off water trapped in the grooves directly with a cotton
swab, etc.
■
Precautions to be Taken after Water Draining
Do not use the product with water drops left on it.
•
Doing so might cause call failure or wet clothes, bags, etc.
•
Doing so might cause the earphone/microphone jack, external
connection jack, etc. to short-circuit, causing fire or a fault.
•
Doing so in cold places might cause the water drops to freeze,
resulting in a fault.
Содержание Basio 2
Страница 1: ......